When designing this case for an ESP32-Wroom, it was important to me that the ESP is particularly well protected inside. Therefore, the case features a screwable lid with ventilation slots, which is secured with four M2x8 screws. The ESP's PCB holes are inserted into the four sockets in the case, ensuring it is securely installed and cannot slip. The ESP's height allows for easy installation of jumper cables, which can be routed out of the case through a slot on the side. The USB-C charging port on the front of the case allows for easy charging and programming. If you want to screw the case to a plate or similar, you can use the 4 mm holes built into the case.
 The ESP case is printed from sturdy PLA, and four heat-sealed nuts are included for mounting the lid. The matching M2x8 countersunk screws are also included.
 If you need a smaller case without jumper cable assembly or have any questions or suggestions, please feel free to contact me!

 If desired, an ESP 32 Wroom can also be ordered under "Options".

 The required hole spacing of the ESP32-Wroom: 47 mm x 23 mm
 The size of the ESP case including lid: L/W/H 70 mm x 39 mm x 41 mm.